79
3. Pull the element into the oven and disconnect the
wires.
Bake element screws
Broil element:
1. Disconnect power from the range.
2. Remove the two screws holding the element to the
oven liner.
3. Remove the two element hangers by removing the
one screw from each and pull the element into the
oven.
4. Disconnect the wires.
Broil element and hanger screws
Fan blade (convection/speed bake models):
1. Disconnect power from the range.
2. Remove the two screws holding the fan cover to the
oven liner and remove the cover.
Fan cover screws
3. Hold the fan blade and remove the nut by turning
clockwise with a 1/2” wrench.
4. With the nut remove pull the fan blade off the shaft.
1/2” wrench
Convection assist element removal:
1. Disconnect power from the range.
2. Remove the fan cover.
3. Remove the two screws holding the element to the
oven liner.
4. Pull the element into the oven and disconnect the
wires.
Assist element screws
Oven vent (coil element models):
1. Remove the two screws holding the vent to the oven
liner and pull the vent into the oven.
To Next Page
Loading...
