Motor and transmission
Service
manual
44
1
2
Note! Console, pulley, arm, the small belt and
the spring can be replaced separately.
Motor all tumble dryers
Description
The motor is located at the bottom of the
tumble dryer. The drive belt of the drum is
coupled to a transmission wheel mounted next
to the motor shaft, and a spring keeps the belt
tightening constant.
The motor has an integrated thermofuse which
breaks the current in the case of overheating.
The fan wheel is mounted directly on the motor
shaft, fig. 1.
On the condensate tumble dryer a separate fan
motor is added on the tumbler rear plate.
See next page.
Replacement:
Replacement of the motor can be carried out
after disassembling the tumble dryer.
• Multi-plug and earthing wires are removed.
Note! If the motor is replaced complete with fan
wheel, console and pulley, the 4 screws on the
outside bottom of the tumbler must be removed.
Tip! By tilting the disassembled tumble dryer
45° forwards, a good balancing point is found
for removing the 4 bottom screws, fig. 2.
It is possible to change single parts by the
motor.
To Next Page
Loading...
