53
Drum with bearing
Service
manual
Replacement:
Replacement of rollers:
1. Dismount the back plate and take out the
drum, see section for "disassembling the dryer".
2. Unscrew the four screws at the front of the dryer,
fig. 1.
3. Remove the flange from the rear side of the door
opening, fig. 2.
4. Replace the new roller by pulling the damaged
roller out and pressing the new roller in place,
fig. 3.
Note! The two locking pins, has to be disengaged,
fig. 4.
1
2
4
3
Rollers
Pins
To Next Page
Loading...
