36
4.0
Install the CGR Wire Harness
and
Route the Wires
4.1 Attach the CGR 25-pin D-sub Connector to the CGR:
4.2 Connect the EDC 5V-Serial Output Wire to the CGR 5V-Serial Input Wire:
4.3 Connect the CGR Harness to the Master Warning and Caution Lights:
4.4 Connect the CGR Harness to the Voice Alarm Control Panel (OEM Only):
4.5 Connect the CGR Harness to the Audio Panel (OEM Only):
4.6 Connect the CGR Harness to the Backlight Control Pot:
4.7 Connect the CGR Harness to Power and Ground:
4.8 Connect the CGR Harness to the CO-Guardian CO Detector:
To Next Page
Loading...
