Example: +2
Daylight savings time in Zurich (CH)
Int. Interval of position determination in seconds
Lower values = more frequent position determination, higher power consumtion
Higher values = less frequent position determination, lower power consumtion
Note: While recording, the position determination is paused for performance reasons.
10
Setup 5/7
SD Card
SD card setup
Write BATPARS Write the current settings to the BATPARS.XML file
Delete BATPARS Delete the BATPARS.XML file from the SD card
Format SD Card Format the SD card
CAUTION: All data on the SD card will be deleted. Make sure that you have made a backup.
Setup 6/7
Miscellaneous
Various settings
Backl.Mode Set the display backlight
0 = Backlight off during recording
1 = Backlight dimmed during recording
2 = Backlight bright during recording
(except in recording mode, the display backlight is always bright; in sleep mode the light is
always off)
1
Load Defaults Set settings back to factory defaults
Setup 7/7
Exit Setup
Exit Setup menu and save changes
Save to BATPARS Write settings to BATPARS.XML file and exit Setup menu
Save to int.Mem Write settings to internal memory and exit Setup menu
If the BATPARS.XML file exists on the SD card, those settings will be loaded on the next
start of the BATLOGGER.
Discard changes Discard changes and exit Setup menu
BATLOGGER Handbuch Elekon AG Nov. 2012 19/28
To Next Page
Loading...