2322
USEA
SWITCHING ON THE APPLIANCE
The machine switches on by pressing the button marked with the symbol placed on
the working front of the same.
When the machine is switched on, it automatically loads water into the boiler and, only when
the boiler is full, does it switch on the heating, so as not to damage the heating elements.
The following alerts are displayed by the pushbuttons:
When switching on the machine all leds of all pushbuttons are flashing for 3 seconds, it
means that the night cicle function is set on.
See paragraphs “3 NIGHT CYCLE” e “5.4 NIGHT CYCLE SETUP”.
1
NIGHT CYCLE
Through the setting of a time of day, the machine enters into a state of partial operation
during which the temperature in the boiler is kept at a very low temperature (40°C).
In this state buttons with automatic dosing are not enabled, only the manual dosing
buttons can be operated.
The following alert is displayed on the pushbuttons during the night cycle:
When this period of time has elapsed, the machine resumes normal operation.
See the following paragraphs.
Such cycle, as it does not cool down the machine completely, allows less scale deposits to
accumulate in its hydraulic components and to save energy.
See following paragraph 5.4 and chapter “C ADJUSTMENTS”, paragraph 1.2
3
DISPLAY OF FUNDAMENTAL PARAMETERS
The following operating parameters can be read on the dual pressure gauge:
- BOILER PRESSURE
- WATER SUPPLY PRESSURE (with pump off).
- BREWING PRESSURE (with pump on).
4
SWITCHING ON THE LIGHTING (Classic)
The body lighting turns on automatically when the machine is switched on.
2
(wait: machine is heating up)
(machine in sleep mode - night cycle)
(machine ready)
OPERATION INSTRUCTIONS
THESE INSTRUCTIONS ARE INTENDED FOR
BARMAN/ESPRESSO COFFEE MACHINE OPERATOR
To Next Page
Loading...
Need help?
General
