ELEKTRA SIXTIES - 5 OPERATING PARAMETERS SETTING; 5.1 COFFEE DOSES SETTING; 5.2 GROUP 1 COFFEES DOSES COPYING ON GROUP 2 AND 3

2524
5 - The group 1 single long coffee selection is displayed as follows:
6 - Press the button to display the group 1 single long coffee sample request as
shown below (pressing on the contrary the “+” button you select group 1 double short
coffees - see step 8):
7 - Make a sample coffee by pressing the group 1 button. Press the button again
when the desired dose has been reached: the pushbutton led goes off, the dose is
stored and you pass automatically to the group 1 double short coffees selection menu.
8 - The group 1 double short coffees selection is displayed as follows:
9 - Press the button to display the group 1 double short coffee samples request
as shown below (pressing on the contrary the “+” key you select group 1 double long
coffees - see step 11):
10 - Make two sample coffees by pressing the group 1 button.
Press the button again when the desired dose has been reached: the pushbutton led
goes off, the dose is stored and you pass automatically to the group 1 double long
coffees selection menu.
11 - The group 1 double long coffees selection is displayed as follows:
12 - Press the button to display the group 1 double long coffee samples
request as shown below:
13 - Make two sample coffees by pressing the group 1 button.
Press the button again when the desired dose has been reached: the pushbutton led
goes off, the dose is stored and the machine pass automatically to be ready for use.
GROUP 1 COFFEES DOSES COPYING ON GROUP 2 AND 3
To copy the coffee doses of group 1 on group 2 and 3 switch the machine on by
pressing the button marked with the symbol keeping contemporaneously pressed
the button of the group 1.
5.1 COFFEE DOSES SETTING
It allows to record the desired doses on each of the four push buttons
, independently for each group, starting from hot machine ready
for use.
Switch the machine on by pressing the button marked with the symbol keeping
contemporaneously pressed the button of the desired group.
All the buttons are programmed making one or two sample coffees with the desired
dose, as per following procedure, for example on the group 1:
1 - The group 1 selection is displayed as shown below:
2 - Press the button to display the group 1 single short coffee selection as
shown below:
3 - Press the button to display the group 1 single short coffee sample request
as shown below (pressing on the contrary the “+” button you select group 1 single long
coffee - see step 5):
4 - Make a sample coffee by pressing the group 1 button. Press the button again
when the desired dose has been reached: the pushbutton led goes off, the dose is
stored and you pass automatically to the group 1 single long coffee selection.
OPERATING PARAMETERS SETTING
It is allowed to set the following operating parameters of the appliance:
- GROUP 1 COFFEE BREWING DOSES PROGRAMMING
- GROUP 2 COFFEE BREWING DOSES PROGRAMMING
- GROUP 3 COFFEE BREWING DOSES PROGRAMMING
- GROUP 1 COFFEES DOSES COPYING ON GROUPS 2 AND 3
- GROUP 1 CLEANING
- GROUP 2 CLEANING
- GROUP 3 CLEANING
- NIGHT CYCLE SETUP
as for the following instructions:
5
5.2