Elektro-Automatik PS 9000 T Series User Manual

Page 33
EA Elektro-Automatik GmbH
Helmholtzstr. 31-33 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
www.elektroautomatik.de
ea1974@elektroautomatik.de
PS 9000 T Series
2.3.8.3 Alternative drivers
In case the CDC drivers described above are not available on your system, or for some reason do not function
correctly, commercial suppliers can help. Search the Internet for suppliers using the keywords “cdc driver windows“
or “cdc driver linux“ or “cdc driver macos“.
2.3.9 Initial commission
Fortherststart-upafterinstallationofthedevice,thefollowingprocedureshavetobeexecuted:
• Conrmthattheconnectioncablestobeusedareofasatisfactorycrosssection!
• Check if the factory settings of set values, safety and monitoring functions and communication are suitable for
your intended application of the device and adjust them if required, as described in the manual!
• In case of remote control via PC, read the additional documentation for interfaces and software!
• In case of remote control via the analog interface, read the section in this manual concerning analog interfaces!
2.3.10 Commission after a rmware update or a long period of non-use
Incaseofarmwareupdate,returnoftheequipmentfollowingrepairoralocationorcongurationchange,similar
measures should be taken to those of initial start up. Refer to „2.3.9. Initial commission“.
Only after successful checking of the device as listed may it be operated as usual.

Elektro-Automatik PS 9000 T Series Specifications

General

Brand	Elektro-Automatik
Model	PS 9000 T Series
Category	Power Supply
Language	English