Need help?Do you have a question about the Element P303BT and is the answer not in the manual?
Provides programming instructions for the Element 2D Barcode Reader.
Details the fast scanning and decoding accuracy of the Element 2D Barcode Reader.
Explains how to restore the scanner engine to its factory default settings.
Describes how to display the firmware version number of the scanner.
Covers the basic steps to power on and initiate Bluetooth scanner connection.
Instructions to connect the scanner via a Bluetooth cradle.
Steps to connect the scanner as a Bluetooth keyboard.
Steps to connect the scanner as a Bluetooth serial port.
Restores the Bluetooth cradle/dongle to its factory default settings.
Sets the data transmission speed for the cradle/dongle.
Configure serial communication parameters like data bits, parity, and stop bits.
Enables USB HID-KB feature for keyboard input via USB.
Enables serial port communication via USB connection.
Configures transmission rates and various transfer modes including synchronous, asynchronous, and mass storage.
Configures how the scanner is activated for scanning.
Sets the scanner to operate in presentation mode for automatic scanning.
Enables automatic sensing for switching between Presentation and Trigger modes.
Configures the inverse color display setting for scanning.
Adjusts the illumination settings for different scanning modes and levels.
Enables or disables the audible confirmation for a successful scan.
Sets the volume level for the good read beep.
Sets the delay time after a successful scan is confirmed.
Configures the minimum time between consecutive scans.
Configures general data formatting options like adding CR, LF, CRLF, or TAB.
Allows setting a custom prefix to be added to scanned data.
Allows setting a custom suffix to be added to scanned data.
Resets all configured prefixes and suffixes to default.
Provides general settings for barcode symbologies, including enabling/disabling all.
Enables or disables all barcode symbologies simultaneously.
Enables or disables the Code 128 barcode symbology.
Configure EAN-8 symbology, including check digit transmission and add-on codes.
Configure EAN-13 symbology, including check digit transmission and add-on codes.
Configure UPC-E symbology, including expansion, check digits, and add-on codes.
Configure UPC-A symbology, including check digits, add-on codes, and number system.
Configure Interleaved 2 of 5 symbology, message length, and check character validation.
Configure Matrix 2 of 5 symbology, including message length.
Configure Industrial 2 of 5 symbology, including message length.
Configure Code 39 symbology, including start/stop characters and check character.
Configure Coda Bar symbology, message length, and start/stop characters.
Configure Code 93 symbology, message length, and append function.
Configure GS1-128 symbology, including message length.
Configure Code 11 symbology, including check digits.
Configure PDF 417 and Micro PDF 417 symbologies, including message length.
Configure QR Code symbology, message length, and append function.
Configure Data Matrix symbology, including message length.
Configure Maxi code symbology, including message length.
Configure Aztec symbology, including message length.
Lists AIM ID table with symbology, AIM ID, remark, and element hex values.
Provides an ASCII table with Hex, Dec, Char, and predefined keystrokes.
Displays digit barcodes (0-9, A-F) with their corresponding codes.
To Next Page
General