Element P303BT - Power Setting; Standby time; Bluetooth Cradle;Dongle Settings; Cradle Factory Defaults

Element P303BT User Guide I Page 8 of 53
2.1.7 Power Setting
Power Off
2.1.8 Standby time
The scanner will power off if no operation is done within the standby time.
1h
30min
10min
Never Power off
2.2 Bluetooth Cradle/Dongle Settings
Connect a scanner to Bluetooth cradle or dongle at first and then you can configure the cradle/dongle.
2.2.1 Cradle Factory Defaults
Scan the barcode below can restore the cradle to factory defaults.
Restore Cradle Factory Defaults
2.2.2 Baud Rate
Baud rate is the number of bits of data transmitted per second. Set the baud rate to match the Host
requirements.