Element4 Sky - Page 31

31
ENCLOSING the FIREPLACE
Element4 Gas Fireplaces EuropeanHome.com
When enclosing the Sky T replace there is a minimum clear area which must be maintained. Nothing except the Sky T may be within
this area. When enclosed, the Sky T is centered - left to right and front to back - within this minimum area, above. This minimum area
MUST BE DEFINED BY NON-COMBUSTIBLE MATERIAL. The inside of the enclosing walls (including any necessary framing) may be no
less than the distances shown above.
Note! The front and rear nished walls must be at least 1⁄”/28 mm thick or the replace trim will extend beyond the nished walls.
We recommend that the replace be set into its nal location before building the enclosure.
SKY T
FINISHED WALL INNER LIMIT
FINISHED WALL INNER LIMIT
MINIMUM AREA REQUIRED FOR SKY T