Element4 Sky - Ignition and Lighting Procedures; Operating Modes and Features

44
OPERATING the FIREPLACE
Element4 Gas Fireplaces EuropeanHome.com
Igniting the Appliance.
On the remote control, simultaneously press and hold the ON/OFF andÇbuttons.
An acoustic signal indicates that the start sequence has begun. Release the buttons.
The electronic system then checks that the main gas is owing and ignites the both burners; this may take up to 20 seconds.
Upon start up the main burner is turned on and the second burner is switched to its last operating setting.
Operating the Second Burner.
Simultaneously press the SET and theÈbuttons to turn the second burner ON.
Simultaneously press the SET and theÇbuttons to turn the second burner OFF.
Changing the Mode of Operation.
Briey pressing the SET button changes the mode of operation in the following order:
Man - Temp - Temp - Timer - back to Man
Man - Manual Flame Height Adjustment.
To increase the ame, theÇbutton should be depressed. Pressing theÈbutton on the handset will reduce the ame. The main
ame may be lowered all the way down until it is o, leaving only the pilot ignited. This is called standby mode.
Fully Extinguishing the Appliance
From any heat setting, press the ON/OFF button for a few seconds. This will cause the burners to fully extinguish.
The system has a safety interlock which will not allow the ignition until the interlock rests. This may take a few minutes.
The appliance should be shut o completely using the ON/OFF button on the handset and not left on pilot only, except for
temporary use. This resets the system and all safety features.
Temp - Daytime Temperature mode.
The appliance must be in standby mode, pilot ignited. The room temperature is measured and compared to the set temperature.
The ame height is then automatically adjusted to reach the daytime set temperature.
Temp - Nighttime setback Temperature mode.
The appliance must be in standby mode, pilot ignited. The room temperature is measured and compared to the nighttime
setback temperature. The ame height is then automatically adjusted to achieve the nighttime setback temperature.
next burner Temp cycle.
Press OFF to complete the program.
UP
DOWN
USING THE REMOTE CONTROL ELECTRONIC IGNITION SYSTEM
ON/OFF
SET
HOW TO LIGHT YOUR FIREPLACE
Note: The system shuts o the appliance completely if there is no change in the
ame height for 5 days.
Setting °C/24 Hour or °F/12 Hour Clock.
Press ON/OFF andÈto toggle between °F/12 hr and °C/24 hr clock.
Setting the time.
Simultaneously press theÈand Çbuttons, the display will ash.
PressÇto set the hour andÈto set the minute.
Press ON/OFF to return to manual mode.
Remote Control