PAR. DESCRIPTION RANGE APP1 APP2 APP3 APP4 M.U.
H12 Configuration of digital input 2/polarity. Same as H11 -9 ... +9 0 0 0 0 num
H21
Configurability of digital output 1 (
).
0 = disabled; 1 = compressor; 2 = defrost; 3 = fans;
4 = alarm; 5 = AUX; 6 = Standby
0 ... 6 1 1 1 1 num
H22
Configurability of digital output 2 (
). Same as H21
0 ... 6 2 2 5 2 num
H23
Configurability of digital output 3 (
). Same as H21
0 ... 6 3 3 3 3 num
H25
Enable/Disable buzzer.
0 = Disabled; 4=Enabled; 1-2-3-5-6-7-8= not used
0 ... 8 0 0 0 0 num
H31
Configurability of UP key.
0 = disabled; 1 = defrost; 2 = AUX; 3 = economy Setpoint; 4 = Standby;
5 = reset HACCP alarms; 6 = disable HACCP alarms; 7 = Deep Cooling.
0 ... 7 1 1 1 1 num
H32 Configurability of DOWN key. Same as H31 0 ... 7 0 0 0 0 num
H42 Evaporator probe present. n = not present; y = present n/y y y y y flag
H43 Probe 3 present. n = not present; y = present n/y n y n n flag
rEL Device version. Read-only parameter / / / / / /
tAb tAble of parameters. Reserved: read-only parameter / / / / / /
COPY CARD (“FPr” folder)
UL Programming parameter transfer from instrument to Copy Card / /
/ / /
/
Fr
Format Copy Card. Erase all data contained in the Copy Card.
NOTE: If parameter “Fr” is used, the data entered will be permanently lost.
This operation cannot be cancelled.
/ / / / / /
FUNCTIONS (“FnC” folder)
rAP Reset pressure switch alarms / / / / / /
rES Reset HACCP alarms / / / / / /
NOTE
: If one or more parameters marked with (!) are modified, the controller MUST be switched off and then switched on again to ensure correct operation.
To Next Page
Loading...
Need help?
General
