Elkay EZH2O - Page 9

Page 9
(630) 574-8484 2000002005
(Rev. B - 01/25)
Elkay Manufacturing Company
DSSBF8SP DSSBF8SP-W1
7. Remove the top access panel by removing the four
phillips screws on the top of the cooler unit using a
phillips screwdriver.
8. Connect the unit water line to shut-o󰀨 valve.
Note: Shut-o valve not shown (installer supplied part).
9. Connect the water inlet tube to the inlet of lter
assembly.
10. Installation of lter.
a. Remove the lter from the carton.
b. Remove the protective cap.
c. Mark the current date on the water lter label.
d. Attach the lter to the lter head with label facing
outward by rmly inserting into the head and by
rotating the lter head clockwise, if required.
Note: Filter label should be readable from the front of
the lter during installation.
11. Use the four phillips screws to install the top access
panel on top of the cooler unit. Tighten the four phillips
screws fully using a phillips screwdriver.
12. Secure the cooler unit to the oor using the existing
holes in the base plate with anchor fasteners.
Top Access
Panel
Screw
Anchor
fastener
Filter
MMDDYY
Top Access
Panel
Screw
Water Inlet
Tube
Filter Inlet