3
1.800.383.5547
•
Use a 110-Volt, 20 amp, 60 Hz
grounded power circuit.
•
No GFCI (Ground Fault Circuit
Interrupter).
•
Adapters, extension cords and surge
protectors will prove to be problematic
with the drill press.
GENERAL INFORMATION
•
For optimum performance, the Variable Speed
Control Box assembly is preset at the factory (Ellis).
•
Adjusting speed and torque (see page 8).
•
Lubrication and maintenance (see page 18).
•
Adjusting table (see page 13).
•
Powered by 110 Volts, the Variable Speed Control
Box (#4830) converts and drives a three-phase,
220-Volt electric motor at variable speeds.
•
Needs 220 Volts (#4831).
INSTALLATION INSTRUCTIONS
The Ellis Variable Speed Drill Press is crated and
shipped completely assembled.
•
Check for transit damage upon delivery.
•
After uncrating, place the drill press on a at, solid
oor within reach of a power source.
•
If the drill press rocks, place shims under the base
to remove motion.
•
Bolt the machine to the oor using four (4) holes
in base.
•
Unpainted surfaces are protected with a lm of
heavy grease.
•
Remove grease with mineral spirits.
•
Apply a thin coat of oil to machined surfaces.
•
Morse Taper Bore must be cleaned of grease
using mineral spirits and by twisting a rag up into
the bore.
Thank you for purchasing the Ellis Model
9400 Drill Press (2HP–110V or 220V).
This machine is suitable for:
•
Drilling, Reaming and Tapping:
Metal, Metal Alloys, Plastic, or Wood.
FEATURES
•
Three (3) speed ranges controlled by a Variable
Speed (VS) Control Box.
•
Three (3) torque ranges by moving a shift handle
with locking feature.
•
One switch for forward and reversing direction.
BEFORE USING THIS DRILL PRESS
•
Read this manual carefully for operation and
maintenance of this drill press.
•
Keep the drill press in good operational condition.
•
Keep it clean.
•
Do NOT tamper with the wiring or settings—
this will void the warranty.
PROPER ELECTRICAL
INSTALLATION/CONNECTION
IMPORTANT INFORMATION!!
WARNING:
To Next Page
Loading...