Ellis 9400 - MACHINE MAINTENANCE PROCEDURES; LUBRICATION SCHEDULE AND TYPE; STANDARD MAINTENANCE TASKS

EllisSaw.com
18
Grease
Fittings
LUBRICATION
The Power Feed Unit Box has two (2) grease ttings.
It is important that the operator grease the machine
frequently. Use Lithium Grease. Do not mix
synthetic and mineral based grease.
Location
Suggested
Lubricant
Frequency
Grease Fittings
(2)
Lithium Grease
N.L.G.I. #2
Monthly or after
25–30 hours
of use
LUBRICATION SCHEDULE
MAINTENANCE
STANDARD MAINTENANCE
•
Keep table and sliding parts clean of dirt and chips.
•
Every three months lower the quill, wipe clean and
oil lightly. If raising the table becomes difcult,
clean and wipe the column with light machine oil.
•
The ball bearings in the motor, quill and V-Belt
pulleys are sealed bearings.
•
Keep the cooling ns of the VS Control Box and the
motor clean and free of dirt and dust.
•
Check V-Belts for tension and excessive wear.