Elma Elmasolvex SE - 10 Operating Faults

Operating faults
© Elma Schmidbauer GmbH BA_Elmasolvex_SE_EN_Vers. 03.2018
41
10 Operating faults
A list of the possible faults and the procedures for fault
clearance can be found in Chapter 10.1.
If any fault cannot be rectified using the measures specified in
the troubleshooting, contact the dealer or manufacturer
immediately.
10.1 Operating faults
Fault
Fault clearance
Cleaning machine cannot be
started or stops.
Check the following possibilities:
• Disconnect cleaning machine from the mains power supply.
Then check fuse(s) (Fig. 3.9.1/2 D) for mains cable; replace if
necessary
• Switch off cleaning machine and restart.
Contact Service if the fault persists.
Timer (STEP TIME) does not
run
Check the following possibilities:
• Disconnect cleaning machine from the mains power supply.
Then check fuse(s) (Fig. 3.9.1/2 D) for mains cable; replace if
necessary
• Switch off cleaning machine and restart.
Contact Service if the fault persists.
Speed (SPEED) can no
longer be adjusted
Check the following possibilities:
• Disconnect cleaning machine from the mains power supply.
Then check fuse(s) (Fig. 3.9.1/2 D) for mains cable; replace if
necessary
• Switch off cleaning machine and restart.
Contact Service if the fault persists.
Indicator lamp in the heater
button does not light
Check the following possibilities:
• Disconnect cleaning machine from the mains power supply.
Then check fuse(s) (Fig. 3.9.1/2 D) for mains cable; replace if
necessary
• Switch off cleaning machine and restart.
Contact Service if the fault persists.
Parts do not become dry
• Replace filter in the fan (Chapter 8.3.3)
• Contact Service if the fault persists.
Internal fan does not function
(no fan noise, no air flow)
Shut down operation – contact Service!