Nov. 2022
MX-P3 Firmware update
[How to check MX-P3 firmware version]
1. Connect the HDMI and RGB terminals to a monitor, projector, etc., and press the MX-
P3's power button to activate the camera.
2. When the image is displayed on the monitor or projector, press and hold the button
(about 2 seconds). Menu appears on the screen.
Use the and buttons to move the cursor, and use the button to
determine the setting value. The menu is displayed as shown below. The part surrounded
by the blue line is the cursor position.
3. Select the item [FW version] from the menu.
4. Displays the MX-P3 camera firmware version.
To Next Page
Need help?
General
