What to do if no image is displayed from the USB on Elmo TT-02S?
If you're not getting an image from the USB connection on your Elmo Document Camera, make sure the DIP switch is set to [RGB].
How to fix Elmo Document Camera when no image is displayed?
If your Elmo Document Camera displays no image, start by checking all cable connections to ensure they are secure. Verify that the AC adapter is properly connected to both the wall outlet and the document camera's power supply socket. Also, confirm that the power supply is turned ON, indicated by a green light. If the zoom is at the TELE side, adjust it appropriately. If the unit doesn't start immediately after being turned off, wait a few seconds before turning it back on. Finally, ensure the dip switch is set to the correct image output (RGB/VIDEO).
Why is my Elmo Document Camera image out of focus?
If the image on your Elmo Document Camera is out of focus, check the distance of the document from the lens. If the document (object) is too close, adjust the distance. Also, if zoom is set at the TELE side after focusing at a wide angle (WIDE side), focus to its maximum limit at the TELE side.
General| Brand | Elmo |
|---|---|
| Model | TT-02S |
| Category | Document Camera |
| Language | English |
To Next Page
