EasyManuals Logo

ELNA 2000 Series User Manual

ELNA 2000 Series
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Winding a Bobbin
1. Pull out the flywheel to keep the needle from
moving up and down.
2. Place the spool of thread on the spool pin with
the thread coming off the spool as shown. Pull
the thread over around the bobbin winder thread
guide.
3. Pass the thread through the hole in the bobbin
from inside to the outside. Place the bobbin on
the bobbin winder spindle.
4. Push the bobbin winder spindle to the right.
5. Hold the free end of the thread and press the
foot control. Stop the machine when it has made
a few turns and cut the thread tail close to the
hole in the bobbin.
6. Press the foot control again until the bobbin is fully
wound. Return the bobbin winder spindle to the
left and cut the thread.
7. Push the flywheel back into place. (The machine
needle will not go up and down until you push in
the flywheel.)
13
1
2
3
4
5
6
7

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ELNA 2000 Series and is the answer not in the manual?

ELNA 2000 Series Specifications

General IconGeneral
Drop FeedYes
Free ArmYes
Adjustable Stitch LengthYes
Adjustable Stitch WidthYes
Stitch OptionsDecorative
Presser FeetButtonhole Foot, Zipper Foot

Related product manuals