3-Step Zigzag
The 3-step zigzag (sometimes called a multiple zig-
zag) is used to finish raw seam edges. This stitch
gives a flatter edge finish than the regular zigzag. It
is also used for mending tears in fabric.
Place the fabric under the presser foot so the needle
swings off the fabric to the right or trim away any
excess fabric.
• Mending a Tear
Pull torn edges together and fuse a piece of interfac-
ing slightly larger than the tear to the wrong side of
the garment.
Begin sewing above the tear. Stitch down the middle,
pulling edges together. Stop sewing just beyond end
of tear. Depending on the tear, you might need to
stitch area 2 or 3 times.
25
4
0
1
2
3
4
0
1
2
3
4
4
To Next Page
Loading...
Need help?
General
