ELNA Zig Zag Cl. 21 User Manual

"No Turn" Buttonhole
-without turning the material
Buttonhole 3/16 " (4 mm) wide.
It may be preferable, first to make a trial button-
hole on a scrap of material. Use thin thread.
~ 2-4-2-4-0 ~ %- Y.
Fig.77
Decenter the needle to the left.
Set the stitch width lever at position "2", mark
"j;J" "~"
Iii or ~ on top.
Fig.78
Sew the first side of the buttonhole. Raise the
needle.
Fig.79
Decenter the needle to the right.
Push the "instant reverse lever" completely to
the right and sew with an open zigzag back to
the beginning of the first row of stitches.
Release
the "instant reverse lever" . Raise the
needle.
Fig.80
Set the stitch width lever at position "4".
Sew a few stitches. Raise the needle.
Fig.81
Set the stitch width lever at position "2 " and sew
the second
side of the buttonhole, but ma ke this
slightly shorter than the first side. Raise the needle.
Fig. 82
Set the stitch width lever at position"4" and finish
the buttonhole by sewing a few more stitches.
Raise
the needle.
Fig.83
Set the stitch width lever at position "0" and
fasten
the threads with a few stitches whilst
holding back the material by hand.
77
79

ELNA Zig Zag Cl. 21 Specifications

General

Brand	ELNA
Model	Zig Zag Cl. 21
Category	Sewing Machine
Language	English