Elstat ems55advanced User Manual

description Enables the input from the motion sensor.
considerations Must be disabled if a motion sensor is not fitted.
range 00 (disabled) or 01 (enabled)
global default 01 (enabled)
10.37 set point (SPC or SPF)
The table below details the set point (SPC or SPF) parameter.
display
description
Defines the compressor cut-out temperature during the ready mode. The set point (SP) temperature is
the lowest measured temperature under normal operating conditions.
The set point is displayed as SPC (set point Celsius) or S PF (set point Fahrenheit) depending on whether
the ems controller is set to use Celsius or Fahrenheit.
considerations Must be above the freeze-up protection (dtt) temperature.
range -9.9 to 9.9°C (14 to 50°F)
global default
3.0°C (37°F)
ems75sz: -3.0°C (27°F)
10.38 saving restart period (Sr)
The table below details the saving restart period (Sr) parameter.
display
description
Defines the maximum time allocated to reach the set point (SP) temperature from the saving mode tem-
perature.
considerations
l Set and verified by OEMs through the test protocol to ensure that product temperatures are within specification
when outlets open.
l Must be set in multiples of 30 minutes.
range 0 to 240 minutes (in multiples of 30 minutes)
global default 120 minutes
10.39 saving set point (SSP)
The table below details the saving set point (SSP) parameter.
ems55advanced and ems55Radvanced / General Use
80 of 84

Elstat ems55advanced Specifications

General

Brand	Elstat
Model	ems55advanced
Category	Controller
Language	English