9.2.3 New or revised parameters 66
9.3 Temperature setting rules 66
9.4 Celsius or Fahrenheit (CF) 67
9.5 Set point (SPC or SPF) 67
9.6 Differential (dIF) 67
9.7 Calibration 1 (CA1) 68
9.8 Calibration 2 (CA2) 68
9.9 Saving set point (SSP) 68
9.10 Saving differential (Sd) 69
9.11 Freeze-up protection (dtt) 69
9.12 Fan set point (FSP) 69
9.13 Condenser high temperature (Ht) 70
9.14 Defrost activation temperature (ddt) 70
9.15 Defrost termination temperature (dtd) 71
9.16 Compressor rest time (rt) 71
9.17 Delay to saving (dS) 72
9.18 Lights delay (Ld) 72
9.19 Saving restart period (Sr) 72
9.20 Refrigeration system failure (Ct) 72
9.21 Defrost interval (dE) 73
9.22 Defrost duration (dd) 73
9.23 Defrost method (dF) 73
9.24 Defrost termination method (dtF) 74
9.25 Fan cycle on (FCO) 74
9.26 Fan cycle off (FCF) 74
9.27 Display stability (d2) 75
9.28 Buzzer enable (b0) 75
9.29 Buzzer duration (b1) 76
9.30 Alarm delay (Ad) 76
9.31 Activity frequency (AF) 76
9.32 Motion sensor enable (Sn) 77
9.33 Saving temperature disable (PEr) 77
9.34 Learning period (LP) 77
9.35 Display (dIS) 78
9.36 Marketing mode (Ar) 78
9.37 Defrost heater (dHr) 78
10 What variations of the ems75sz (sub zero) can I order? 80
10.1 Examples of CDM colours 81
11 Technical data ems75sz 82
11.1 Dimensional drawings: 82
11.2 Controller relays: 82
11.3 Temperature sensors: 82
11.4 Environmental ratings: 83
11.5 Product approvals: 83
12 Glossary of terms 84
12.1 Acronyms 84
12.2 Controller and accessory terms 84
3 of 86
27 February 2014
To Next Page
Loading...
