8.8 How to troubleshoot motion sensor alarms
The motion detection LED flashes to indicate that movement has been detected.
However, a motion sensor LED flashing continuously may indicate that the motion sensor is faulty or,
if a motion sensor is not fitted, that the parameter settings are incorrect.
Note:
l The EMS controller stays in the ready mode if the motion detection LED is flashing continuously.
For information about the motion sensor enable (S n ) parameter:
l See "Motion sensor enable (Sn)" on page 77
Follow the chart to troubleshoot problems with the motion sensor.
8.9 How to troubleshoot not cooling problems
Follow the chart below to troubleshoot problems of the cooler not cooling, i.e. the cooler or product
is warm.
61 of 86
27 February 2014
To Next Page
Loading...
Need help?
General
