Elstat Nexo CMS200 - High voltage (HI)

Product Manual, Issue 6 CMS200
www.nexo.comPage 54
6.3.22 High voltage (HI)
Display
Description
Denes the maximum voltage allowed before switching o the compressor. The high
voltage (HI) values are 10% of the actual line in voltages (see table below).
Considerations
• Must not be used with an external voltage stabiliser
• Must only be used with the following Elstat supplied power supply modules (PSM):
30001-0102 or 30002-0102
Global default 0 (disabled)
110-120V line 220-240V line
voltage HI voltage HI
Disabled 0 220 22
120 12 230 23
130 13 240 24
140 14 250 25
260 26
270 27
Note: Voltage measurement is accurate to typically ±10%
Caution
Voltage management operation, as described above, will only operate reliably when
power is supplied by the following power supply modules: Elstat Sub Zero PSM part
number- 30001-0102, (120V) variant, or 30002-0102, (240V) variant.
If Elstat ems 75 SZ PSM part number 3101-0102, (120V) variant, or part number 33102-
0102, (240V) variant, are used then the voltage management operation and the alarms
that it will produce cannot be relied upon to accurately reect the state of the mains
power supply, and subsequent damage may occur to the cooler.
High voltage protection is not calibrated and actual performance can be inuenced by
several factors. Therefore, total protection cannot be guaranteed.