Model 2000 Flow Computer Instruction Manual
APPENDIX 2 AUDIT LOG EVENT CODES
Model 2000 issue 21 Page No
73
APPENDIX 2 Event Codes
The following is a list of Events that can be recorded by the Model 2000 in the event log.
Event Status Code EVENT TYPE
0 No Event
1 Power ON
2 Reset
3 New .S19 file downloaded
4 Event log cleared
5 Calibration Data changed
6 Front Panel Settings changed
7 New Time/Date Set using EDIT mode
8 New Time/Date Set using M2000 Windows Software
9 New Time/Date Set using Modbus communication
10 Preset Data changed using EDIT mode
11 Preset Data changed using M2000 Windows Software
12 Modbus Data written to M2000
13 Maintenance Mode switched ON
14 Maintenance Mode switched OFF
15 Proving Mode switched ON
16 Proving Mode switched OFF
17 P/T Calibrate Mode switched ON
18 P/T Calibrate Mode switched OFF
19 Security Switch No 1 changed from OFF to ON
29 Security Switch No 1 changed from ON to OFF
21 Security Switch No 2 changed from OFF to ON
22 Security Switch No 2 changed from ON to OFF
23 Security Switch No 3 changed from OFF to ON
24 Security Switch No 3 changed from ON to OFF
25 Security Switch No 4 changed from OFF to ON
26 Security Switch No 4 changed from ON to OFF
27 Totals Hold Button operated
28 All Alarm History cleared
29 Fault History cleared
30 Accountable Alarm History cleared
31 Non Accountable Alarm History cleared
32 Warnings History cleared
33 Display pages have changed
34 Information pages have changed
35 Input Board settings have changed
36 Output Board settings have changed by EDIT mode
37 Output Board settings have changed by M2000 Windows software
38 Modbus settings have changed
39 Print Job settings have changed
40 Data to Print settings have changed
41 Port Settings have changed
42 Unit Security settings have changed
43 Ethernet settings have changed
44 Counter Prefix table has changed
45 Preset ids in Event log have changed
To Next Page
Loading...