Buzz
10
emax-usa.com
Binding Procedure
Binding is the process of uniquely associating a receiver to a transmitter module. A
transmitter module can be bound to multiple receivers (not to be used
simultaneously). A receiver can only be bound to one transmitter module.
Follow the steps below to finish the binding procedure.
1. Power on Buzz while holding the BIND button on the module (please refer to the
module instruction manual for switch positions). Release the button when a green
light starts flashing.
2. Turn on the transmitter (radio controller) and put it into bind mode for a D16
module.
3. A red light will start flashing on the receiver indicating binding process was
successful
4. Turn the radio out of bind mode and power off Buzz to save bind settings.
Thank you for purchasing our product! Enjoy Flying Buzz.
Please visit emax-usa.com or emaxmodel.com for any updates or support needs.
Warning：
Please pay attention to your surroundings. Not
Recommended for persons under 18 years of age.
To Previous Page
Loading...
