EMC VNX5500 - Page 48

48 EMC VNX5500 Parts Location Guide
Disk-array enclosure (DAE)
Disk drive
To access the disk drives, first slide out the 40U, 60 DAE from the rack. Then, push the top
cover towards the rear of the chassis. The disk drives are located on either sides of the
LCCs in the DAE (Figure 41 on page 47).
Figure 43 shows the location of the 4U, 60 DAE disk drive part number label.
Figure 43 Example of the 4U, 60 DAE disk drive part number label location
Table 30 lists the part number label location, part number, description, and whether it is a
FRU or CRU.
IMPORTANT
Due to the extensive variety of disk module types, Table 30 only lists two disk types. EMC
recommends that you refer to the latest
EMC VNX5100 and VNX5300 Series Storage
Systems Disk and OE Matrix
Guide to ensure that you have the correct part for your
configuration.
Fan control module
To access the fan control modules, first slide out the 40U, 60 DAE from the rack. Then,
push the top cover towards the rear of the chassis. The fan control modules are located in
the front of the DAE (Figure 41 on page 47).
Part number (P/N) label
VNX-000672
Table 30 DAE 4U, 60 disk module part numbers
Part number label
location
(Figure 43) Part number Description (see note) FRU CRU
005049284 600 GB, 6 Gb/s SAS, 10k rpm 
005049207 900 GB, 6 Gb/s SAS, 10K rpm 
Note: The description field describes the disk module type, capacity, drive type, and spindle
speed (rpm).