EMC VNX5500 - Page 52

52 EMC VNX5500 Parts Location Guide
Disk-array enclosure (DAE)
Table 35 lists the part number label location, part number, description, and whether it is a
FRU or CRU.
Table 35 4U, 60 (2.5- or 3.5-inch) DAE ICM and power supply part numbers
Part number label
location
(Figure 48 on
page 51) Part number Description FRU CRU
1 303-172-000C ICM B
1

2 071-000-545 Power supply B
2
, dual AC input,
1300 W, +12 V

Note: If the 4U, 60 (2.5- or 3.5-inch) DAE is located higher than 31U in the Dense rack, then both
the ICM and power supply are FRUs.
1. The rear of the 4U, 60 (2.5- or 3.5-inch) DAE has the ICM on opposite sides of the DAE. In other words, ICM A
is located on the left of the DAE and ICM B is located on the right (Figure 48 on page 51).
2. The rear of the 2U, 60 (2.5- or 3.5-inch) DAE has the DAE power supplies between ICM A and B. In other
words, power supply A is located on the left of the DAE and power supply B is located on the right (Figure 48
on page 51).
Copyright © 2012 EMC Corporation. All rights reserved. Published in the USA.
Published June 26, 2012
EMC believes the information in this publication is accurate as of its publication date. The information is subject to change without
notice.
The information in this publication is provided as is. EMC Corporation makes no representations or warranties of any
kind with respect to the information in this publication, and specifically disclaims implied warranties of
merchantability or fitness for a particular purpose. Use, copying, and distribution of any EMC software described in this
publication requires an applicable software license.
EMC
2
, EMC, and the EMC logo are registered trademarks or trademarks of EMC Corporation in the United States and other countries.
All other trademarks used herein are the property of their respective owners.
For the most up-to-date regulatory document for your product line, go to the technical documentation and advisories
section on EMC Online Support.