EMDEKO LT-72 - Button Sewing Foot

To Next Page

To Previous Page

D. BUTTON SEWING FOOT

Be sure to set the Buttonhole Dial at "M" and zig zag Dial at ": "

Attach button sewing foot to presser bar. Drop the fabric feeders below the needle

plate by pushing the "DARN" button.

After the fabric is placed under the foot, put the button between the fabric and

the button sewing foot. Slowly turn the fly wheel toward you by hand, passing the

needle through the left eye of the button. When the needle is half way through the

button, carefully, with the presser bar lifter, lower the button sewing foot on the

button.

Turn the fly wheel by hand toward you until the needle raises out of the button

to its highest position. Continue turning the fly wheel until the point of the needle

is just above the button. Adjust the stitch width with the zig zag regulating dial.

NOTE: The needle will move from left to right.

Run the machine at medium speed, making 6 or 7 stitches. Raise the needle out

of the button. Set the zig zag dial at ":" Make several stitches through

the left eye of the button. This will lock the stitches.

You will be able to sew on four eye button by following the same procedure.

Upper thread

Lower thread-

Fig. 51

Fig. 52