EMDEKO LT-72 - Threading Bobbin Case

To Next Page

To Previous Page

6. ADJUSTING BOBBIN WINDER

1. If the thread winds as in Fig.

9, move the bobbin winder

thread guide (F) to slight

down by turning the bobbin

winder regulating screw (E)

to the clockwise, and tighten

the screw by turning to cou-

nterclockwise.

2.If the thread winds as in Fig.

10 move the bobbin winder

thread guide (F) to slightly

upper by turning the bobbin

winder regulating screw (E)

to the clockwise, and tighten

the screw by turning to coun

terclockwise.

7. THREADING BOBBIN CASE

Fig. 9

Fig. 10

Fig. 12

Fig. 11

1. Hold the bobbin case between the left thumb and forefinger with the slot up.

With 5 or 6 inches of thread trailing in the palm, hold the bobbin between the

thumb and first two fingers of right hand.

2. Insert the bobbin into the bobbin case, then pull the trailing thread into the slot,

up to the left until it enters the delivery eye under the tension spring. There

should be a slight tension on the thread as it pulls through the delivery eye.

SLOT

TENSION

SPRING

Fig. 13