E. HEMMER FOOT
CAUTION: Be sure to make the following arrangements.
1. Set zig zag dial at " : ".
2. Set Buttonhole Dial at "M "
1. Straight Stitch Narrow Hem
Attach the hemmer foot. Then adjust the stitch length to medium size.
Fold the material over about 1/8 inch, then insert the fold beneath the hemmer
into the scroll by moving the material back and forward gently and hem rolls into
the scroll of the hemmer foot.
After the material is properly inserted into the hemmer foot, pull the material
toward you until the end of the material is just below the needle. Lower the
presser bar, then sew the first few stitches slowly while holding the hem between
the thumb and forefinger of the right hand.
CAUTION: Do not feed the material too fast or too slow into the hemmer.
2. Narrow Rolled Edge
Set zig zag dial at #2, then follow same procedure as in making straight
stitch narrow hem.
Scroll
Fig. 53 Fig. 54
26
To Next Page
Loading...