29. OILING THE MACHINE
As is the case with all precision machinery, it is necessary for maximum efficiency
to properly oil and clean at reasonable intervals. Even though the machine is not
in constant use, it is important to oil your machine since the oil will dry after
standing over a period of time.
The underside of the machine should be oiled at the arrow points as shown in
Fig. 59.
NOTE: Before oiling, clean away all lint or foreign matter. One or two drops
are sufficient at each point.
The machine should be oiled at the arrow points as shown in Fig. 60. These parts
are accessible by opening the face plate.
To oil the top parts of your machine, remove the screw (A), remove *O"
cam first then remove top cover and oil the parts located at the arrow points
as in Fig. 61.
NOTE: After you have cleaned and oiled your machine, it is advisable to run
the machine at high speed so the oil will penetrate all moving parts.
CAUION: After cleaning and oiling machine, wipe away all excess oil. and
sew on waste material.
ally
Fig. 59
Fig. 60
Fig. 61
28
To Next Page
Loading...