Gateway are operationally equivalent and the following instructions are applicable to
both.
Powering the Gateway
For the Emerson 1410S, bench top power will be needed to power the Gateway by wiring a
10.5–30 VDC (24 VDC if configured with I.S. barriers) power source. See Power
specifications for power requirements or Reference data for specifications.
Figure 2-1: Emerson 1410S Gateway Wiring
A. Mounting plate
B. Emerson Wireless 781S Smart Antenna terminal 1 power and data connections
C. Emerson Wireless 781S Smart Antenna terminal 2 power and data connections
D. Ethernet port 1. When this port is activated, the factory IP address is 192.168.1.10.
E. Ethernet port 2. When this port is activated, the factory IP address is 192.168.2.10.
F. Emerson 1410S power and serial connections
CAUTION
Equipment damage
Connecting through the open terminal block cover (the lower cover) may stress the
connections and damage the Gateway.
When making physical connections to the Gateway it is important to use the electrical
conduit entries located on the bottom of the housing.
2.3.1 Establishing a connection
Connect the PC/laptop to the Ethernet 1 (Primary) receptacle on the Gateway using an
Ethernet cable. This process will only need to be done once for the two networks. The
networks have the same IP address even if you are running two separate networks.
Configuration Reference Manual
May 2020 00809-0600-4410
8 Emerson.com
To Next Page
Loading...
