2 Configuration
2.1 Wireless planning
Power up sequences
The Gateway should be installed and functioning properly before power modules are
installed in any wireless field devices. Wireless field devices should also be powered up in
order of proximity from the Gateway beginning with the closest. This will result in a
simpler and faster network installation.
Antenna positions
The 781S Smart Antenna should be positioned vertically and be approximately 6 ft. (2 m)
from large structures or buildings to allow for clear communication to other devices. If
using two Emerson 781S Smart Antennas, each should be mounted at least 3 ft. (0.91 m)
from one another.
2.2 PC requirements
Operating system (optional software only)
For security set up, Microsoft supported Windows operating systems are acceptable. See
some examples shown below:
• Microsoft
®
Windows
™
Server 2008 (Standard Edition), Service Pack 2
• Windows 10 Enterprise, Service Pack 1
Applications
Configuration of the Gateway is done through a secure web interface. Recent versions of
the following browsers are supported:
• Chrome
™
browser
• Mozilla Firefox
®
• Microsoft Edge
Hard disk space - (WirelessHART only)
• AMS Wireless Configurator: 1.5 GB
• Gateway Security Setup CD: 250 MB
2.3 Initial connection and configuration
Initial connection
To configure the Gateway, a local connection between a computer and the Gateway needs
to be established. The WirelessHART
®
and ISA100 networks in the Emerson 1410S
Reference Manual Configuration
00809-0600-4410 May 2020
Emerson 1410S/781S 7
To Next Page
Loading...
