EasyManua.ls Logo

Emerson 1410S - Page 89

Emerson 1410S
134 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
N1 ATEX Increased Safety with Intrinsically Safe Outputs to Zone 2
Certificate
SGS20ATEX0057X
Markings
II 3G Ex ec [ic] IIC T4 Gc (-40°C ≤ Ta ≤ +65°C)
Standards
EN IEC 60079-0: 2018, EN IEC 60079-7:2015+A1:2018, EN
60079-11: 2012, EN 60079-15:2010, EN 60079-31:2014
N1 ATEX Increased Safety with Intrinsically Safe Outputs to Zone 2 (For
use only with the Cisco Outdoor Access Point Model IW-6300H-AC-x-K9)
Certificate
SGS20ATEX0057X
Markings
II 3G Ex ec nA [ic] IIC T4 Gc (-40°C ≤ Ta ≤ +65°C)
Standards
EN IEC 60079-0: 2018, EN IEC 60079-7:2015+A1:2018, EN
60079-11: 2012, EN 60079-15:2010, EN 60079-31:2014
Special Conditions for Safe Use (X):
1. The enclosure’s polyurethane paint finish may constitute an
electrostatic hazard. Care should be taken to protect it from external
conditions conducive to the build-up of electrostatic charge on such
surfaces. The equipment must only be cleaned with a damp cloth.
2. The non-intrinsically safe Supply, Modbus RTU & Ethernet Port
connections of the equipment must be supplied from either safety
extra low-voltage (SELV) or protective extra low-voltage (PELV)
circuits, for example equipment complying with the requirements of
either the IEC 60950 series, IEC 61010-1 or a technically equivalent
standard.
3. The equipment is not capable of withstanding the 500V electrical
strength test as defined in clause 6.1 of EN 60079-7:2015+ A1:2018
and 6.3.13 EN 60079-11:2012. This must be taken into account
during installation.
ND ATEX Dust-Ignition Proof with Intrinsically Safe Outputs to Zone 0
Certificate
SGS20ATEX0036X
Markings
II 3D (1G) Ex tc [ia IIC Ga] IIIC T90°C Dc (-40°C ≤ Ta ≤ +65°C)
Standards
EN IEC 60079-0: 2018, EN IEC 60079-7:2015+A1:2018, EN
60079-11: 2012, EN 60079-15:2010, EN 60079-31:2014
Special Conditions for Safe Use (X):
1.
The enclosure’s polyurethane paint finish may constitute an
electrostatic hazard. Care should be taken to protect it from external
conditions conducive to the build-up of electrostatic charge on such
surfaces. The equipment must only be cleaned with a damp cloth.
Quick Start Guide March 2020
22 Emerson.com

Table of Contents

Other manuals for Emerson 1410S

Related product manuals