Emerson AMS 6500 - Wire termination at the AMS 6500

Prepare individual twisted pair cable for terminationFigure 6-4:
Measurements are not to scale.
Foil shield requires wire tag or heat shrink to prevent unraveling.
A. Foil shield
B. 24 AWG
C. Shield drain
6.3 Wire termination at the AMS 6500
AMS 6500 sensor cables terminate in three different ways:
1. Directly into the 12-2-2 modules at a A6500-M-RTRM rear termination panel.
2. At the inputs on the A6500-P-RTRM termination panel. Buffered outputs can then
be routed to the 12-2-2 modules with DIP switches.
3. At DIN rail-mounted terminal blocks inside the cabinet/enclosure, then connected
to prediction modules or protection module inputs with additional short wiring
runs.
6.3.1 Rear termination panel
The rear termination panel plugs directly onto the backplane. This termination panel has
connectors for sensor inputs, tachometer inputs, and discrete input/output relays into the
12-2-2 modules. All these connections are available through BNC connectors on the rear of
the AMS 2600.
Wire terminations
MHM-97125-PBF-EN, R0 37