3. Connect the terminated Ethernet cable to the NIC.
4. Secure the network cable to the right side of enclosure using a cable tie-down.
NIC and HUB connectorsFigure 6-10:
A. Rear HUB connector
B. Rear NIC connector
Use the NIC connector when connecting to an Ethernet hub or switch.
Use the HUB connector when connecting directly to a PC (the HUB connector provides the
same function as a crossover cable).
6.12 Default schema for network addressing
The network arrangement shown assumes one of the AMS 6500 units include Transient
functionality.
Wire terminations
50 MHM-97125-PBF-EN, R0
To Next Page
Loading...
