Emerson Bettis G Series - Page 45

Installation, Operation and Maintenance Manual
VA-DC-000-1878 Rev. 0 December 2020
41
Section 5: Module Removal and Installation
Module Removal and Installation
5.8.2 Lubricate two spherical washers (1 - 40), and one extension rod assembly (1 - 50).
5.8.3 Install one spherical washer (1 - 40) into the side of guide block (1 - 30).
NOTE:
The spherical side of washer (1 - 40) will be facing to the outside of guide block (1 - 30).
5.8.4 Install second spherical washer (1 - 40) over threaded end of extension rod
assembly (1 - 50).
NOTE:
The spherical side of the washer will go on the extension rod assembly facing the head of
the extension rod assembly.
5.8.5 Install extension rod assembly (1 - 50) into right of guide block (1 - 30) and up
against the rst spherical washer (1 - 40).
5.8.6 Install extension retainer nut assembly (1 - 60) over extension rod assembly
(1 - 50) and screw into guide block (1 - 30).
5.8.7 Tighten extension retainer nut assembly (1 - 60) until extension rod assembly
(1 - 50) cannot move. Back off the extension retainer nut assembly (1 - 60) just
enough to allow for extension rod assembly (1 - 50) to move freely.