100-214-251 REV. 05 23
6 Test Switch
Activates ultrasonic power and places the ultrasonic
power supply module into Test (autotune) mode for
approximately 6 seconds). While this switch is pressed,
power displays on both the NUMERIC DISPLAY and the
POWER BARGRAPH. When you release TEST, the welder
returns to the READY state. You can select the scale
factor for Test mode by setting the Test Scale Multiplier
DIP Switch to 1x or 2x. Refer to Section 4.11.1 Setting
DIP Switches for further information about DIP
settings.
7 Horn Down Switch
Selects the HORN DOWN mode. When pressed, the
switch LED will light. Pressing the START SWITCHES
while in the Horn Down mode will bring the carriage
down without triggering ultrasonics. Pressing the
switch again will de-select HORN DOWN mode.
8 AB Time Switch
Selects the afterburst TIME parameter for modification
when display lock is inactive; displays the AB TIME
parameter in the NUMERIC DISPLAY, and lights the AB
TIME switch LED.
9 AB Delay Switch
Selects the Afterburst DELAY parameter for
modification when display lock is inactive; displays the
AB DELAY parameter in the NUMERIC DISPLAY, and
lights the AB DELAY switch LED.
10 Hold Time Switch
Selects the Hold Time parameter for modification when
display lock is inactive; displays the Hold parameter in
the NUMERIC DISPLAY, and lights the Hold Time switch
LED.
11 Weld Time Switch
Selects the Weld Time parameter for modification when
display lock is inactive; displays the Weld parameter in
the NUMERIC DISPLAY; and lights the Hold Time switch
LED.
Table 2.2 Front Panel Displays, IW
Item Name Function
100-214-251 IWoper.book Page 23 Friday, June 16, 2017 4:12 PM
To Next Page
Loading...