12 Digitax ST Installation Guide
www.controltechniques.com Issue: 2
Figure 3-2 Minimum mounting clearances
*2mm clearance between drives to allow for mechanical tolerance.
Digitax ST can be mounted using a DIN rail, either fixed at the top or the bottom of the
drive (as illustrated in Figure 3-3). Two screws are required to fix the drive to the
backplate at the opposite end to the DIN rail.
Figure 3-3 DIN rail mounting
100mm (4in)
100mm (4in)
*2mm (0.08in)
47mm (1.85in)
312.7mm
(12.31in)
To Next Page
Loading...
