Digitax ST Installation Guide 3
Issue: 2 www.controltechniques.com
Contents
1 Safety Information ...............................................................5
1.1 Warnings, Cautions and Notes ................................................................5
1.2 Electrical safety - general warning ..........................................................5
1.3 System design and safety of personnel ..................................................5
1.4 Environmental limits ................................................................................6
1.5 Compliance with regulations ...................................................................6
1.6 Motor .......................................................................................................6
1.7 Adjusting parameters ..............................................................................6
1.8 Electrical installation ................................................................................6
2 Introduction .........................................................................8
2.1 Features of the drive ...............................................................................9
2.2 Items supplied with the drive ...................................................................9
3 Mechanical Installation .....................................................11
3.1 Drive ......................................................................................................11
3.2 Braking ..................................................................................................13
3.3 External EMC filter ................................................................................14
4 Electrical Installation ........................................................15
4.1 Power terminal connections ..................................................................15
4.2 Ground leakage .....................................................................................17
4.3 EMC ......................................................................................................18
4.4 Control terminals ...................................................................................21
4.5 Recommended simple start-up .............................................................27