Emerson Digitax ST User Manual

Safety
Information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
EtherCAT
interface
SMARTCARD
Operation
Onboard
PLC
Advanced
parameters
Technical
Data
Diagnostics
UL listing
information
Digitax ST User Guide 105
Issue: 5
Gives the type/mode of the data block selected with Pr 11.37
Gives the version number of the data block selected in Pr 11.37.
Gives the checksum of the data block selected in Pr 11.37.
N
If Pr 11.42 is equal to 1 or 2, this value is not transferred to the drive or
saved to the EEPROM. If Pr 11.42 is set to a 3 or 4 the value is
transferred.
nonE (0) = Inactive
rEAd (1) = Read parameter set from the SMARTCARD
Prog (2) = Programming a parameter set to the SMARTCARD
Auto (3) = Auto save
boot (4) = Boot mode
11.38 SMARTCARD data type/mode
RO Txt NC PT
Ú
0 to 18
Ö
Pr 11.38 String Type/mode Data stored
0FrEE
Value when Pr 11.37 = 0, 1000 to
1003
1 Reserved
2 3OpEn.LP Open-loop mode parameters
Data from
EEPROM
6 to 8 3Un Unused
9 Reserved
10 4OpEn.LP Open-loop mode parameters
Defaults last
loaded and
differences
11 4CL.VECt Closed-loop vector mode parameters
14 to 16 4Un Unused
17 LAddEr Onboard PLC program
18 Option A Solutions Module file
19 Opt.Prg
Solutions Module program data block
present
11.39 SMARTCARD data version
RW Uni NC
Ú
0 to 9,999
Ö
0
11.40 SMARTCARD data checksum
R0 Uni NC PT
Ú
0 to 65,335
Ö
11.42 {0.30} Parameter copying
RW Txt NC US*
Ú
0 to 4
Ö
nonE (0)
NOTE

Emerson Digitax ST Specifications

General

Brand	Emerson
Model	Digitax ST
Category	Controller
Language	English