6 • XR35CX I&O Manual 026-1203 Rev 3 03-FEB-2015
6 Main Functions
6.1. How to See the
Setpoint
1.Push and immediately release the
SET key: the display will show the set-
point value.
2.Push and immediately release the
SET key or wait for 5 seconds to dis-
play the probe value again.
6.2. How to Change the
Setpoint
1. Push the SET key for more than 2 seconds to change
the setpoint value.
2. The value of the setpoint will be displayed and the
°C or °F LED starts blinking.
3. To change the setpoint value, push the UP or
DOWN arrow keys within 10 seconds.
4. To memorize the new setpoint value, push the SET
key again or wait 10 seconds.
6.3. How to Start a Manual
Defrost
Push the DEF key for more than 2
seconds and a manual defrost will
start.
6.4. How to Change a
Parameter Value
To change the parameter’s value operate as fol-
lows:
1. Enter the Programming mode by pressing the SET
+ DOWN arrow keys for 3 seconds (the °C or °F
LED starts blinking).
2. Select the required parameter (refer to Section 7,
Parameters for the list of parameters). Press the
SET key to display its value.
3. Use the UP or DOWN arrow keys to change its val-
ue.
4. Press SET to store the new value and move to the
following parameter.
5. To exit, press SET + UP arrow keys or wait 15 sec-
onds without pressing a key.
6.5. The Hidden Menu
The Hidden Menu includes all the parameters of
the controller.
6.5.1. How to Enter the Hidden
Menu
1. Enter the Programming mode by pressing the SET
+ DOWN arrow keys for 3 seconds (the °C or °F
LED starts blinking).
2. Immediately release the keys, then push the SET +
DOWN arrow keys again for more than 7 seconds.
The Pr2 label will be displayed immediately fol-
lowed by the Hy parameter. NOW YOU ARE IN
THE HIDDEN MENU.
3. Select the required parameter. See Section 7, Pa-
rameters for the list of parameters.
4. Press the SET key to display its value.
5. Use the UP or DOWN arrow keys to change its val-
ue.
6. Press SET to store the new value and move to the
next parameter.
7. Press SET + DOWN arrow keys or wait for 15 sec-
onds without pressing a key to exit.
NOTE: The set value is stored even when the
time-out expires and ends the procedure.
NOTE: If a parameter is not present in Pr1, the
noP message is displayed after 3 seconds. Keep
the keys pressed until the Pr2 message is dis-
played.
NOTE: The set value is stored even when the
time-out expires and ends the procedure.
To Next Page
Loading...
