Why am I receiving a false alarm from my Emerson Security System FA-700?
If your Emerson Security System FA-700 is positioned too close to a window during the winter months (below 45°C) or in direct sunlight (above 85°C), this could cause it to trigger a false alarm. Also, a false alarm may occur if no batteries are installed. Check the FA-700 to ensure batteries are installed.
What to do if my Emerson Security System FA-700 does not call out during a test?
If the Emerson Security System FA-700 does not call out during a test, first ensure that the FA-700 has power and that the phone service is working properly (you should hear a dial tone). Then, check that the RJ-11 phone cord is fully plugged into both the phone jack of the FA-700 and the wall jack. Re-enter the phone number, verifying the area code and whether the number “1” is required for long-distance calling. If you're using a phone calling card, ensure the calling sequence includes any necessary pauses to complete the call.
How to cancel an alarm call out on the Emerson Security System FA-700?
If you cannot cancel the alarm call out and the Emerson Security System FA-700 continues calling, verify that you hear an alarm message indicating that the call out has been canceled. Also, ensure that you are pressing the correct cancel alarm keys—the number “1” key followed by the pound “#” key—within one minute of the alarm event.
Why doesn't my Emerson Security System FA-700 answer when I call?
The Emerson Security System FA-700 will not answer if there is no active alarm event in progress. Verify that phone service is active at the FA-700 location. Check if there is an answering machine or voice mail in line with the FA-700.
What to do if I cannot enter a phone number on my Emerson Security System FA-700?
If you cannot enter the phone number into your Emerson Security System FA-700, check that the FA-700’s AC power adapter is properly plugged into AC power. Then, carefully follow the “Entering Phone Number” procedure.
How to fix an Emerson Security System if the FA-700 power LED is not lit?
If the power LED on your Emerson Security System FA-700 is not lit, first, check that the barrel connector end of the AC adapter is plugged into the power jack on the FA-700, and that the other end of the adapter is plugged into a ‘live’ AC power source. Also, verify that the AC power wall outlet is active.
Details crucial safety precautions and warnings related to installation, operation, and potential hazards.
Introduces the initial setup phase, including connecting AC power and related safety warnings.
Step-by-step guide to programming the FA-700 with a call-to phone number.
Guidance on ideal setup and performing a phone test to verify functionality.
Detailed steps for performing a functional test of the FA-700's alarm calling capability.
Methods for cancelling the FA-700's outgoing alarm calls both remotely and locally.
Procedures for cancelling an active alarm call-out by calling the FA-700.
Addresses problems like power issues, failure to call out, false alarms, and call cancellation errors.
General| Brand | Emerson |
|---|---|
| Model | FA-700 |
| Category | Security System |
| Language | English |
To Next Page
