Changing the call-to phone number
Follow the “entering phone number” procedure to overwrite the call-to phone number.
Installation considerations
The FA-700 should be installed in a dry, clean location near an AC power outlet and a
telephone wall jack.
• Do not install or connect your FA-700 monitor to power or phone lines during a lightning
storm. Failure to observe this warning could result in an electrical shock.
• Do not install in a confined space, such as a bookcase or in a cabinet, in direct sunlight or
where it might get exposed to water. Failure to observe this caution could result in poor
performance or damage to the FA-700.
• Use ONLY the AC power adapter supplied. The use of other AC power adapters could result
in damage to the FA-700.
• Do not install in high dust and debris areas. Failure to observe this caution could result in
damage to the FA-700.
• Do not install in an area with chemical fumes or corrosive vapors. Failure to observe this
caution could result in damage to the FA-700.
FA-700 assembled
Figure 6 shows an example of an ideal setup. Place the FA-700 on any flat surface, preferably
a table top near an AC Power outlet and a phone jack as shown in Figure 6. Once the FA-700
is fully assembled and operational (power LED ON), perform a phone test to ensure that the
FA-700 can call the call-to phone number during an alarm.
Figure 6: FA-700 Assembled
Phone test
After entering the call-to phone number, it is crucial that you test your FA-700 to verify that
it can reach the programmed phone number.
Note: The CANCEL key does not function when the FA-700 is in “test mode.”
To Next Page
Loading...