• Power LED does not turn ON while running on
batteries.
• Is the barrel connector end of the AC adapter plugged
into the power jack on the FA-700, with the other end
of the adapter plugged into a ‘live” AC power source?
• Is the AC power wall outlet active?
CANNOT enter phone
number
• You cannot enter the call-to phone number if the FA-
700 is being powered only by batteries.
• Is the FA-700’s AC power adapter plugged into AC
power?
• Follow the “Entering Phone Number” procedure.
FA-700 DOES NOT call out
during a test
• Does the FA-700 have power?
• Is the phone service working properly (dial tone)?
• Re-check that the RJ-11 phone cord is fully plugged
into the phone jack of the FA-700, and into the wall
jack.
• Re-enter the phone number, verify area code and if
the number “1” is required for long distance calling.
• If you are using a phone calling card, check to see that
the calling sequence includes pauses as may be
necessary to complete the call.
FA-700 does not answer
when I call
• The FA-700 will not answer if there is no active alarm
event in progress.
• Is there an answering machine or voice mail in line
with the FA-700? (see procedure for “In phone line
answering machine/voice mail”)
• Verify that phone service is active at FA-700 location.
I cannot cancel the alarm call
out; the FA-700 continues
calling out
• Do you hear an alarm message that the alarm call out
has been canceled?
• Are you pressing the correct cancel alarm keys during
the alarm event: number “1” key and then the pound
“#” key within one minute?
• The FA-700’s temperature sensor is accurate to within
3°F of the actual temperature. If your FA-700 is too close
to a window during the winter months (below 45°C) or
positioned in direct sun light (above 85°C) this could
cause the FA-700 to false alarm.
• Check the FA-700 to see if the batteries installed, No
batteries installed could cause the FA-700 to issue a
false alarm.
To Next Page
Loading...