DVC6000f Digital Valve Controllers
December 2009
7-20
DVC6000f Troubleshooting Checklist
Reference
1. Instrument serial number as read from nameplate _________________________________________
2. What is the firmware version of the DVC6000f? _________________
3. What is the hardware version of the DVC6000f? ________________
4. What is the Diagnostic Tier of the DVC6000f? FD___ AD___ PD___
5. What is the Control Tier of the DVC6000f? SC___ FL___ FC___
6. What is the address of the DVC6000f? ________________________
Mode and Status
7. What are the DVC6000f Block Modes?
Actual Modes: Resource Block _____ Transducer Block_____ Analog Output Block _____
Target Modes: Resource Block _____ Transducer Block_____ Analog Output Block _____
Permitted Modes: Resource Block _____ Transducer Block_____ Analog Output Block _____
8. What is the status of the individual function blocks?
Operational
9. Does the digital valve controller respond to the control signal? Yes _________ No _________
If No, describe
10. Is it on Travel or Pressure control?
11. What are the following parameter readings?
Setpoint _________ Drive Signal _________%
Supply Pressure _________ Pressure A _________ Pressure B _________
Travel Target _________% Travel _________% Pressure B _________
12. What is the safe position of the valve? Fail Closed ____ Fail Open ____
Interface and Diagnostic Tools
13. What interface and diagnostic tools are available?___________________________________
14. Provide any available supporting documentation, such as Status Monitor, Detailed Setup, any alert readings.
Mounting
Reference
1. Actuator application: Sliding Stem? ____ Rotary? ____
2. Which digital valve controller do you have? DVC6010f ____ DVC6020f ____ DVC6030f____ or,
Remote mount digital valve controller? DVC6005f with DVC6010f ____ DVC6020f ____ DVC6030f____
3. What Make, Brand, Style, Size, etc. actuator is the DVC6000f mounted on? _________________________
Operational
4. What is the full travel of the valve?__________________________________
5. What is the Mounting Kit part number? ______________________________
Other
6. If mounting kits are made by LBP/Customer, please provide pictures of installation.
7. For a DVC6010f or a DVC6030f: During full travel of the actuator, does the DVC6000f feedback arm move
below the “A” or above the “B” alignment positions? (It should not) Yes____ No ____
7
To Next Page
Loading...
Need help?
General
