Emerson Fisher FIELDVUE DVC6200 HW1 User Manual

www.Fisher.com
Fisher
r
FIELDVUE
™
DVC6200 Series Digital Valve
Controllers
Contents
Before You Begin 3......................................
Step 1. Install the DVC6200 on the Valve 4...................
Step 2. Connect the Pneumatic Tubing 19...................
Step 3. Connect the Electrical Wires 23......................
Step 4. Configure the DVC6200 33.........................
Special Instructions for Safety Instrumented Systems 35.......
Hazardous Area Approvals and Special Instructions for
“Safe Use”and Installations in Hazardous Locations 43.......
Quick Start Guide
D103556X012
DVC6200 Digital Valve Controllers
August 2015
This quick start guide provides installation and initial setup information for DVC6200 Series digital valve controllers
W9713
SIS

Emerson Fisher FIELDVUE DVC6200 HW1 Specifications

General

Manufacturer	Emerson
Model	FIELDVUE DVC6200 HW1
Type	Digital Valve Controller
Input Signal	4-20 mA DC
Communication Protocol	HART
Operating Temperature Range	-40 to 85°C (-40 to 185°F)
Enclosure Rating	NEMA 4X, IP66
Material	Aluminum or Stainless Steel
Certifications	ATEX, IECEx, FM, CSA
Diagnostics	Advanced diagnostics capabilities

Summary

Before You Begin

Safety and Preparation Guidelines

Crucial safety and preparation guidelines before installation.

Step 1. Install the DVC6200 on the Valve

Housing Variations

Describes different DVC6200 housing configurations for actuators.

General Mounting Guidelines

Provides general advice for mounting the digital valve controller.

Use of Magnetic Tools with the DVC6200

Discusses the proper and safe use of magnetic tools.

Sliding-Stem Linear Actuators

Instructions for mounting on sliding-stem linear actuators.

Quarter-Turn Rotary Actuators

Instructions for mounting on quarter-turn rotary actuators.

DVC6205 Remote Mount Base Unit Mounting

Pipestand Mounting

Procedures for mounting the base unit on a pipestand.

Wall Mounting

Procedures for mounting the base unit on a wall.

Step 2. Connect the Pneumatic Tubing

Integral Mounting Pneumatic Connections

Guides on connecting pneumatic tubing for integral mounting.

Filter and Filter Regulator Connections

Details on connecting pneumatic supply filters and regulators.

Step 3. Connect the Electrical Wires

FOUNDATION fieldbus or PROFIBUS PA Wiring

Wiring instructions for fieldbus communication protocols.

HART Device Wiring

Wiring instructions for HART communication.

Position Transmitter or Discrete Switch Wiring

Wiring for optional position transmitter or discrete switch outputs.

Remote Mount Feedback Unit

Wiring the Remote Mount Feedback Unit

Instructions for connecting the feedback unit to the base unit.

Smart Wireless THUM Adapter

THUM Adapter Installation and Wiring

Guides for installing and wiring the THUM adapter.

Step 4. Configure the Digital Valve Controller

User Interface Tools and Software

Lists software and tools for configuration and calibration.

Special Instructions for Safety Instrumented Systems (SIS)

DIP Switch Configuration for SIS

Details DIP switch settings for SIS functionality.

De-Energize to Trip (DETT) Configurations

Instructions for DETT operation with solenoid valves.

Solenoid Valve Health Monitoring

Tubing for Solenoid Valve Health Monitoring

Procedures for monitoring solenoid valve operation.

Hazardous Area Approvals and Special Instructions for Safe Use

CSA Approvals

Safety and installation requirements for CSA certified areas.

FM Approvals

Safety and installation requirements for FM certified areas.

ATEX Approvals

Safety and installation requirements for ATEX certified areas.

IECEx Approvals

Safety and installation requirements for IECEx certified areas.